单臂路由（router-on-a-stick）是指在路由器的一个接口上通过配置子接口（或“逻辑接口”，并不存在真正物理接口）的方式，实现原来相互隔离的不同VLAN（虚拟局域网）之间的互联互通。

环境

• Cisco Packet Tracer 5.3
• Windows 10 ## 操作 操作：按照如图所示连接拓扑图
  

  

  ## ## 实验步骤 （1）创建拓扑，配置设备
  添加一台路由器、一台交换机和四台主机
  
  PC0和PC1与交换机fa0/1、fa0/2 接口连接，划分在VLAN10中，IP分别为192.168.10.1、192.168.10.2，网关192.168.10.254。
  PC2和PC3与交换机fa0/11、fa0/12 接口连接，划分在VLAN20中，IP分别为192.168.20.1、192.168.20.2，网关192.168.20.254。
  交换机fa0/24端口与路由器fa0/1端口连接。
  
  （2）配置交换机 ```bash / Part 1 配置交换机 / Switch>enable Switch#configure terminal Switch(config)#hostname SA SA(config)#vlan 10 SA(config-vlan)#vlan 20 SA(config-vlan)#exit SA(config)#interface range fa0/1-fa0/2 SA(config-if-range)#switchport access vlan 10 SA(config-if-range)#interface range fa0/11-fa0/12 SA(config-if-range)#switchport access vlan 20 SA(config-if-range)#interface fa0/24 SA(config-if)#switchport mode trunk SA(config-if)#switchport trunk allowed vlan all

/ Part 2 检查配置 / SA(config-if-range)#^Z （Ctrl+Z组合键） SA#show vlan ... VLAN Name Status Ports ---- -------------------------------- --------- ------------------------------- 1 default active Fa0/3, Fa0/4, Fa0/5, Fa0/6

Fa0/7, Fa0/8, Fa0/9, Fa0/10
Fa0/13, Fa0/14, Fa0/15, Fa0/16
Fa0/17, Fa0/18, Fa0/19, Fa0/20
Fa0/21, Fa0/22, Fa0/23

10 VLAN0010 active Fa0/1, Fa0/2 20 VLAN0020 active Fa0/11, Fa0/12 ...

（3）配置路由器

bash / Part 1 配置路由器 / Router>enable Router#configure terminal Router(config)#hostname RA RA(config)#interface fa0/0.1 RA(config-subif)#encapsulation dot1Q 10 // (1:在路由器上配置trunk的封装协议的命令： // encapsulation [isl/dot1q] vlan＃ // 2:上面的路由器配置了dot1q中继封装,10是vlan 10。 // 3:Trunk的封装类型一共有 ISL和802.1Q两种，而802.1Q在输入的时候为dot1q) RA(config-subif)#ip address 192.168.10.254 255.255.255.0 RA(config-subif)#interface fa0/0.2 RA(config-subif)#encapsulation dot1Q 20 RA(config-subif)#ip address 192.168.20.254 255.255.255.0 RA(config-subif)#exit RA(config)#interface fa0/0 RA(config-if)#shutdown RA(config-if)#no shutdown     //（重启fa0/0接口）

/ Part 2 检查配置 / RA>show interfaces fa0/0.1 ... Internet address is 192.168.1.254/24 ... Encapsulation 802.1Q Virtual LAN, Vlan ID 10 ...

RA>show interfaces fa0/0.2 ... Internet address is 192.168.2.254/24 ... Encapsulation 802.1Q Virtual LAN, Vlan ID 20 ...

（4）连通性测试

bash / Part 1 PC0 Ping 自己网关 / PC>ping 192.168.1.254

Pinging 192.168.1.254 with 32 bytes of data:

Reply from 192.168.1.254: bytes=32 time=11ms TTL=255 Reply from 192.168.1.254: bytes=32 time=12ms TTL=255 Reply from 192.168.1.254: bytes=32 time=11ms TTL=255 Reply from 192.168.1.254: bytes=32 time=12ms TTL=255

Ping statistics for 192.168.1.254:

Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),

Approximate round trip times in milli-seconds:

Minimum = 11ms, Maximum = 12ms, Average = 11ms

/ Part 2 PC0 Ping PC1 / PC>ping 192.168.1.2

Pinging 192.168.1.2 with 32 bytes of data:

Reply from 192.168.1.2: bytes=32 time=25ms TTL=128 Reply from 192.168.1.2: bytes=32 time=10ms TTL=128 Reply from 192.168.1.2: bytes=32 time=12ms TTL=128 Reply from 192.168.1.2: bytes=32 time=14ms TTL=128

Ping statistics for 192.168.1.2:

Approximate round trip times in milli-seconds:

/ Part 3 PC0 Ping PC2 PC3网关 / PC>ping 192.168.2.254

Pinging 192.168.2.254 with 32 bytes of data:

Reply from 192.168.2.254: bytes=32 time=11ms TTL=255 Reply from 192.168.2.254: bytes=32 time=14ms TTL=255 Reply from 192.168.2.254: bytes=32 time=11ms TTL=255 Reply from 192.168.2.254: bytes=32 time=12ms TTL=255

Ping statistics for 192.168.2.254:

Approximate round trip times in milli-seconds:

/ Part 4 PC0 Ping PC2 / PC>ping 192.168.2.1

Pinging 192.168.2.1 with 32 bytes of data:

Reply from 192.168.2.1: bytes=32 time=24ms TTL=127 Reply from 192.168.2.1: bytes=32 time=19ms TTL=127 Reply from 192.168.2.1: bytes=32 time=21ms TTL=127 Reply from 192.168.2.1: bytes=32 time=20ms TTL=127

Ping statistics for 192.168.2.1:

Approximate round trip times in milli-seconds:

/ Part 5 PC0 Ping PC3 / PC>ping 192.168.2.2

Pinging 192.168.2.2 with 32 bytes of data:

Request timed out. Reply from 192.168.2.2: bytes=32 time=24ms TTL=127 Reply from 192.168.2.2: bytes=32 time=22ms TTL=127 Reply from 192.168.2.2: bytes=32 time=19ms TTL=127

Ping statistics for 192.168.2.2:

Approximate round trip times in milli-seconds: